If you are looking for a way to access the internet from every corner of your house, it is recommended that you perform Netgear extender setup. Setting up a range extender will expand the range of your WiFi network to parts of your home where the signal is poor.
Thus, walk through the step-by-step guidelines mentioned in this article and learn how to set up a Netgear extender in your home using two different methods.
- By using the WPS method
- By accessing the Mywifiext Setup Wizard
How to Perform Netgear Extender Setup Using the WPS Method?
In this method, you won’t have to do much! The WPS method just requires you to press a little button to set up the WiFi extender in your home. Follow the instructions mentioned below in order to install a Netgear extender by pressing the WPS button:
Power On the Netgear Extender
The first step to install any technical device is to set up its hardware. Thus, start by setting up the hardware of the Netgear WiFi extender. Grab a cable and connect the extender to the power adapter. Then, power on the Netgear WiFi range extender.
Connect the Extender to the Router
Once the power LED light turns green, connect the Netgear extender to the WiFi router wirelessly. If you use an Ethernet cable to connect both the WiFi devices, make sure that it isn’t loose or worn out. By any chance, if the cable is damaged, get it replaced immediately!
Press the WPS Button
Has a secure connection been established between the extender and router? Good. Now, look for the WPS button on your extender. Once found, carefully press it. Hold the button for a few seconds before releasing it. As soon as the LED light becomes stable on your device, unplug it and place it at a different location.
By following these instructions, you’ll be able to perform Netgear extender setup by using the WPS method. Now, you are free to connect as many devices with your network as you want without worrying about slow internet.
How to Perform Extender Setup by Accessing the Mywifiext Setup Wizard?
This method is one of the most used methods in the world when it comes to setting up a range extender. Here are the steps that you need to follow in order to set up an extender manually:
Open Up a Web Browser
After configuring the hardware of your Netgear range extender, open up a web browser on your laptop. You can use any web browser that you want. But, make sure that the web browser you use is updated. Otherwise, you won’t be able to successfully set up the extender.
Access the Mywifiext Web Page
The next step in line is to access the mywifiext.net page. Thus, type mywifiext in the address bar of your chosen browser and press the Enter key. You will be taken to the Netgear extender login page. In case you face any issues while trying to log into the extender, make use of the default IP.
Quick Tip: Refer to the Netgear manual to gain information regarding the IP of your device.
Perform Netgear Extender Login
When the Netgear extender login page appears, fill in the default mywifiext.net login details. You need to type the default username and password of your device. Then, click on the Log In button and follow the on-screen instructions. After following the on-screen prompts, click on the Finish button.
Follow the aforementioned instructions in the exact order as they are written. Otherwise, you’ll face unwanted issues during the process of Netgear extender setup.
Conclusion
Once you are done performing Netgear extender setup using these two methods, connect your device to the extended network. If you want to test the extender, try moving around your house with your device.
